Artificial Grass Guide
Football Artificial Turf Installation
Date:2015-11-13
Today we would like to instruct details for installation.
1. Engineering measurement and layout
(1) Check Base project.
Clear away the sundries. If there are rough, should be repaired and make it to flat.
Make sure the environment clean. Then you need to do the base according drawing.
(2) According to the drawing size carefully clear picture on the basis of field on the surface, all marker must be double.
(3) Use tool: double color pencil, steel tape, masonry nail, ink fountain, the hammer
2. Unfold turf
(1) Unfold all the first turf, confirmed there are no fold, cut spare edge.
(2) Then the second volume of grass along the position of the first volume.
(3) Put grass in order to ensure the site of the beautiful, to make the lawn lap compact as possible, but cannot overlap after
trimming, at the same time to ensure that the lawn and turf the edge line of grass not too far apart, the most is the lawn
a row spacing distance.
3. Adhesive seam edge
(1) Will have been repaired evenly fold up the grass rolls edge of 20 to 30 cm, 20 centimeters wide seams on the prepared
between the adjacent grass volume on the basis of, and then evenly daub glue, natural drying after a period of time,
and then put down the seam edge.
(2) Adhesive, the requirements on its surface coating thickness uniformity with the brush, not glue repeatedly,
can appear otherwise foaming phenomenon, or even fall. Will joint coated with glue, strictly control the thickness of
the glue, pay attention to glue to the appropriate speed, glue should apply the glue two bonding surface.
(3) Glue, according to the practical conditions, such as temperature, humidity, air pressure, the reasonable control of
air buy time. Within 10 to 30 minutes after general with glue, mucilage to reach into dry to touch not advisable.
One-time alignment requirement when bonding cement. Must not object moves by adhesive back glue again later.
(4) After the adhesive is good, check the status of glue solidification and the glue is pressurized solidification, special rubber
hammer from sticking it to thump on both sides, make good contact with the surface is close-grained, adhesive firmer.
4. Function Line
(1) Find the marker of the reserved on the lawn, in the middle of the marker position open with a knife, and make it natural
shrink after a period of time, with a good line is drawn along the knife, cut out the location of the marker.
(2) Rolls of white grass cut into the corresponding width of the strip, put it in the reserved marker position, and then with the
green grass beside with 30 centimeters wide seam belt bonding together, craft basic adhesive seam edge with green grass.
5. Infill Sand and Rubber
(1) Put sand in grass first, and then put rubber second.
- Our Blog
- Company News
- Artificial Grass Guide
- CONTACT US
- Tel:86 21 3998 2788
- Mobile:86 13701887891
- Fax:86 21 3998 2785
- Email:sales@topjoyturf.com